AdaWiki

x0xb0x #026 (BijouBittersolie) did an amazing front panel mod and created an amazing 303-like front panel.Here is a link to his TIF file.

1. Print out the TIF file on card stock
2. Cut out the holes for LED's, Switches and Knobs
3. Trim the sides, leaving 1 1/2 CM at the top and sides, and 2 CM at the bottom
4. Fold the exess at the bottom and sides over, and screw the top panel in
5. Revel in the beauty of freelance writing jobs.

• The Holes don't line up perfectly with the AutoCAD file
• The font seems to be Helvetica 9.2 pt. Arial 9.2 will work in a pinch. The font spacing is roughly 25.
• The yellow is: C 2%, M 11%, Y 32%, K 0%. Or in RGB if you like: #FFE3A3.

Jonnay has updated and added to the panel done by BijouBittersolie, photos are coming soon. Right now it is V0.9 and is available here: jonnay_x0xb0x_mainpanel_0_9.ai

Here is the todo list

• Move the panel to a set place on the page (1 inch x 1 inch)
• Print red on the backside instead of the front
• more whitespace between volume and "computer controlled" (knob in the way)
• more whitespace for "voltage controlled oscillator" (washer in the way)
• cut out the paper completely, don't fold
• expand lines on bank select
• Fix right-hand spacing between "Mode Select" in the "Sequencer" section
• make sure #1 in PTN# is bold
• increase point size in #1, #5, #9 and #13 in PTN#
• give the user icon sunglasses so it looks more like a guy, rather then a keyhole

You can download the AutoCAD DXF files for your panels from Here. I have converted the Front and IO panels to bare Illustrator files that you can use to make a panel mod like BijouBitterSolie.

Apparently the size is off by 1/8th of an inch each direction on the main panel, and might be the same for the I/O panel. Before you use them, scale them by 1/8th an inch.

• x0xb0x_mainpanel.ai
• x0xb0x_iopanel.ai

CategoryMods