This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
mdcpickandplace:diytray [2010/10/12 01:05] ladyada |
mdcpickandplace:diytray [2010/10/12 01:20] ladyada |
||
---|---|---|---|
Line 19: | Line 19: | ||
Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer. | Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer. | ||
- | Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer. | + | Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer. Keep the left side loose for later adjustment |
+ | Cut two rails from 1/16" material with 5mm drill holes so that the top edge doesnt rise above the JEDEC tray thickness | ||
+ | |||
+ | Attach the rails with T-slot nuts. | ||
+ | |||
+ | Place the tray on the holder, slide the left side in and tighten. |