Differences

This shows you the differences between two versions of the page.

--- laserinfo:pcb_stencils [2009/05/06 20:23]
ladyada
+++ laserinfo:pcb_stencils [2016/01/28 18:05] (current)
@@ Line 5: / Line 5: @@
 You'll need:
   - A laser cutter
-  - Kapton film, I like the 1 mil thick 1 ft square sheets from [[http://www.mcmaster.com/#2271K2|McMaster-Carr]]
+  - Kapton film, I like the 2 mil thick 1 ft square sheets from [[http://www.mcmaster.com/#2271K2|McMaster-Carr]]
   - Solder paste such as [[http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=KE1507-ND|Kester No-Clean]]
@@ Line 72: / Line 72: @@
 {{:laserinfo:cutstencil.jpg|}}
-I usually use the Dimension layer info to make a jig for silkscreening by cutting out the PCB outline in a 0.062" (1/16th) clear acrylic sheet
+I usually use the Dimension layer info to make a jig for silkscreening by cutting out the PCB outline in a 0.062'' (1/16th) clear acrylic sheet
+Here is a LFCSP 16 (4mm on each side) cut out of 2 mil kapton as above
+{{:laserinfo:lfcspkapton.jpg|}}

AdaWiki