This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
tutorials:products:18tftbreakout:index.html [2012/07/25 17:53] adafruit_support [Introduction] |
tutorials:products:18tftbreakout:index.html [2012/07/25 17:57] adafruit_support [Flexible Wiring] |
||
---|---|---|---|
Line 25: | Line 25: | ||
There are two ways to wire up these displays - one is a more flexible method (you can use any pins on the Arduino) and the other is much faster (4-8x faster, but you are required to use the hardware SPI pins) We will begin by showing how to use the more flexible method. | There are two ways to wire up these displays - one is a more flexible method (you can use any pins on the Arduino) and the other is much faster (4-8x faster, but you are required to use the hardware SPI pins) We will begin by showing how to use the more flexible method. | ||
+ | |||
+ | <class warning> | ||
+ | ** The shield version is pre-wired for hardware SPI. Once you have soldered in the headers, you can skip the wiring instructions and proceed to the "Graphics Library" section for the library code and examples ** | ||
+ | </class> | ||
[[http://www.ladyada.net/images/18tftbreakout/18tftback.jpg|{{ http://www.ladyada.net/images/18tftbreakout/18tftback_t.jpg?nolink&500x385 |}}]] | [[http://www.ladyada.net/images/18tftbreakout/18tftback.jpg|{{ http://www.ladyada.net/images/18tftbreakout/18tftback_t.jpg?nolink&500x385 |}}]] |