This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
mdcpickandplace:diytray [2010/10/12 01:02] ladyada |
mdcpickandplace:diytray [2010/10/12 01:20] ladyada |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | <iframe src="http://player.vimeo.com/video/15752459" width="400" height="225" frameborder="0"></iframe><p><a href="http://vimeo.com/15752459">This old pick and place - making a tray</a> from <a href="http://vimeo.com/adafruit">adafruit industries</a> on <a href="http://vimeo.com">Vimeo</a>.</p> | + | {{ vimeo>15752459 }} |
---- | ---- | ||
Line 15: | Line 14: | ||
Total is $50 | Total is $50 | ||
+ | |||
+ | ====== Quick instructions ====== | ||
+ | |||
+ | Cut the 20mm extrusion into ~18" pieces (make them a little shorter than the pick and place drawer. | ||
+ | |||
+ | Attach the pieces with L-brackets so that the L-brackets face each other on the inside of the holder and the outside right edge is flush with the drawer. Keep the left side loose for later adjustment | ||
+ | |||
+ | Cut two rails from 1/16" material with 5mm drill holes so that the top edge doesnt rise above the JEDEC tray thickness | ||
+ | |||
+ | Attach the rails with T-slot nuts. | ||
+ | |||
+ | Place the tray on the holder, slide the left side in and tighten. |