laserinfo:settings
This is an old revision of the document!
Table of Contents
Settings
Acrylic
For engraving, 100% speed and 55% (600dpi), 65% (400dpi) or 75% power (300dpi) – Epilog Manual
For cutting, use 5000 ppi frequency. Remove the top layer of paper.
REMEMBER THAT ACRYLIC IS FLAMMABLE - DO NOT LEAVE THE LASER UNATTENDED!
| Material | 35W Cut | Notes |
|---|---|---|
| Clear 1/16" (0.062") | 100% power, 20% speed | A clean cut on paperbacked acrylic, higher speed may be OK |
| Clear 1/8" (0.125") | 100% power, 12% speed | From the Epilog Manual |
| Clear 1/4" (0.25") | 100% power, 4% speed | From the Epilog Manual |
Anodized Aluminum
| 35W etch | 45W etch | Notes | |
|---|---|---|---|
| 300 DPI | 100% power, 100% speed | 90% power, 100% speed | From the Epilog Manual |
| 400 DPI | 90% power, 100% speed | 80% power, 100% speed | From the Epilog Manual |
| 600 DPI | 80% power, 100% speed | 70% power, 100% speed | From the Epilog Manual |
iPods
Anodized iPods (Mini, Nano 2G and Shuffle 2G) use standard Anodized Aluminum settings
Leatherman Multitool
For anodized Multitools, use standard Anodized Aluminum settings
Cell phones
http://farm1.static.flickr.com/127/414932490_f6fb0def0b_o.jpg
For phones that are metallized (such as this Motorola RAZR) use standard Anodized Aluminum settings
[Need to do larger phone survey of models! Please add data]
/home/ladyada/public_html/wiki/data/attic/laserinfo/settings.1173403072.txt.gz · Last modified: 2016/01/28 18:05 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
