laserinfo:settings
This is an old revision of the document!
Settings
Acrylic
For engraving, 100% speed and 55% (600dpi), 65% (400dpi) or 75% power (300dpi) – Epilog Manual
For cutting, use 5000 ppi frequency.
| Material | 35W Cut | Notes |
|---|---|---|
| Clear 1/16" (0.062") | 100% power, 20% speed | A clean cut on paperbacked acrylic, higher speed may be OK |
| Clear 1/8" (0.125") | 100% power, 12% speed | From the Epilog Manual |
| Clear 1/4" (0.25") | 100% power, 4% speed | From the Epilog Manual |
/home/ladyada/public_html/wiki/data/attic/laserinfo/settings.1173402387.txt.gz · Last modified: 2016/01/28 18:05 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
