This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
laserinfo:settings [2007/03/09 01:11] ladyada |
laserinfo:settings [2016/01/28 18:05] (current) |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Settings ====== | + | ====== Moved! ====== |
- | ===== Acrylic ===== | + | This tutorial has moved to [[http://learn.adafruit.com/all-about-laser-cutters|http://learn.adafruit.com/all-about-laser-cutters]] |
- | + | ||
- | For engraving, 100% speed and 55% (600dpi), 65% (400dpi) or 75% power (300dpi) -- Epilog Manual | + | |
- | + | ||
- | For cutting, use 5000 ppi frequency. Remove the top layer of paper. | + | |
- | + | ||
- | **REMEMBER THAT ACRYLIC IS FLAMMABLE - DO NOT LEAVE THE LASER UNATTENDED!** | + | |
- | + | ||
- | ^ Material ^ 35W Cut ^ Notes ^ | + | |
- | ^ Clear 1/16" (0.062") | 100% power, 20% speed | A clean cut on paperbacked acrylic, higher speed may be OK | | + | |
- | ^ Clear 1/8" (0.125") | 100% power, 12% speed | From the Epilog Manual | | + | |
- | ^ Clear 1/4" (0.25") | 100% power, 4% speed | From the Epilog Manual | | + | |
- | + | ||
- | ===== Anodized Aluminum ===== | + | |
- | + | ||
- | | ^ 35W etch ^ 45W etch ^ Notes ^ | + | |
- | ^ 300 DPI | 100% power, 100% speed | 90% power, 100% speed | From the Epilog Manual | | + | |
- | ^ 400 DPI | 90% power, 100% speed | 80% power, 100% speed | From the Epilog Manual | | + | |
- | ^ 600 DPI | 80% power, 100% speed | 70% power, 100% speed | From the Epilog Manual | | + | |
- | + | ||
- | ===== iPods ===== | + | |
- | + | ||
- | {{http://farm1.static.flickr.com/165/414932464_370ffce306_o.jpg|http://www.flickr.com/photos/adafruitlaser/414932464/in/photostream/}} | + | |
- | + | ||
- | Anodized iPods (Mini, Nano 2G and Shuffle 2G) use standard Anodized Aluminum settings ( | + |