laserinfo:maintenance
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
laserinfo:maintenance [2009/11/06 19:51] ladyada created |
laserinfo:maintenance [2016/01/28 18:05] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Up-keeping your laser ===== | + | ====== Moved! ====== |
| - | + | ||
| - | Laser cutters are very expensive piece of equipment - chances are you spent over $5,000 on yours (we spent $15k!) which means its important to keep the machine in good condition. There is nothing worse than having a multi-thousand dollar machine destroyed because of a few minutes' negligence. | + | |
| - | + | ||
| - | You don't even need to do that much, to keep everything in top condition! | + | |
| - | + | ||
| - | ===== Always ===== | + | |
| - | + | ||
| - | **Never let the machine run unattended especially when its cutting!** | + | |
| - | + | ||
| - | Acrylic is extremely flammable and it goes without saying that wood, paper, mylar, delrin and other materials are as well | + | |
| - | + | ||
| - | We know of **four** people who have had to essentially replace the machine because it caught on fire unattended. One person had their entire shop burned down because they cut acrylic and left it. | + | |
| - | + | ||
| - | **Never let the machine run unattended especially when its cutting!** | + | |
| - | + | ||
| - | Its simply not worth it! We have never had a fire that damaged the machine because we keep an eye on it and make sure someone is within 3 feet at all times | + | |
| - | + | ||
| - | **Never let the machine run unattended especially when its cutting!** | + | |
| - | + | ||
| - | ===== Daily (after 8-hours of lasering) ===== | + | |
| - | + | ||
| - | Every day, or after 8 hours of solid laser cutting, be sure to check the lens and clean it if necessary. The top lens and mirror are right above the laser beam which means they are exposed to a lot of dirt, fumes, smoke and debris. If the lens gets dirty a few things happen. | + | |
| - | + | ||
| - | # The laser won't cut nearly as well, requiring lower speeds or higher power, to cut | + | |
| - | # The laser won't engrave nearly as well, with uneven results and blurry images | + | |
| - | # Eventually, the dirt on the lens/mirror can catch on fire and melt the lens/mirror permanently damaging it | + | |
| + | This tutorial has moved to [[http://learn.adafruit.com/all-about-laser-cutters|http://learn.adafruit.com/all-about-laser-cutters]] | ||
/home/ladyada/public_html/wiki/data/attic/laserinfo/maintenance.1257537088.txt.gz · Last modified: 2016/01/28 18:05 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
